AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Cetus3d extruder10/26/2022 ![]() Please change the "alpha_dir_pin", "beta_dir_pin", or "gamma_dir_pin" value to include or remove the "!" after the pin number. IMPORTANT: If the extruder is not homing towards the end switch. ![]() NOTE: when using repetier-host please use ping-pong communication setting to ensure a valid ACK is received for each command. Cetus3d extruder software#Using any GCODE capable software send "G28 X" or "G28 Y" to home your axis, this will move the extruder towards the end stop. Next time after you home the z axis if you send G1 Z0 F2000 will move your extruder to the print surface. The result will be your actual Z height and this will be your new gamma_max value.Ĭhange the config gamma_max value and restart the printer. When you have got the extruder to just touch your print bed, using the gamma_max value subtract the Z value you just entered. Move the z axis so that the extruder just about half way to the print surface using "G1 Z100 F2000", then work your way down to the print surface by lowering the Z value. Send "G90" to tell your printer to use absolute position. (WARNING: if the extruder is not moving towards the end switch switch off the printer immediately) The z position is now the value defined in your config file setting "gamma_max". ![]() Using any GCODE capable software send "G28 Z" to home your Z axis, this will move the extruder to the maximum height end stop. Download the correct config file from the download link above. ![]()
0 Comments
Read More
Leave a Reply. |